Monday, March 16, 2009

Anchoring, Scope, Chain & Rode


When you are anchored properly you should look like this photo.  Lets have a closer look at the details;
  • Scope - this is the total amount of chain and rode (rope) you need to put out.
  • We typically use a scope of 5 to 1 (5:1)  for normal conditions in protected waters.
  • We use 7:1 if we are expecting a blow and we have room to swing.
  • How do you calculate the vertical measurement? (depth)+(height from waterline to deck)+(maximum height of tide).
  • Example: 12ft (depth) + 3 ft (water to deck) + 5 ft (max tide) = 20 ft.  Calculate normal scope:  20 ft x 5 = 100 ft.
The reality is your scope will vary depending on how much room you have at the anchorage, how good a bottom there is and the amount of protection you have from the wind.  We always aim for a minimum of 5:1 if we are staying overnite.  If we are just stopping for lunch and not getting off the boat, 3:1 might do.

So how much chain do you need?  Enough to keep you from swinging all over the anchorage.  We used to have just 40 ft of chain on our CS27.  After smacking into another boat at Baddeck while at anchor we added an extra 40 ft.  Some say you only need the a weight of chain equivalent to the weight of your anchor (too complicated for me) - in our opinion, this is not enough.

All chain for a smaller boat is not practical either - too much weight in the bow.  On our CS27 we has our 22 lb Delta anchor connected to 80 ft of 1/4 " chain, which was spliced to 200 ft of 1/2 inch 3-strand nylon rode.  Why 80 ft?  Well, we normally anchor in 10 ft to 20 ft of water so we would typically put out a minimum of 80 ft in 10 ft of water (scope 5:1 - how much tide am I expecting?).  If I was doing it again I would have 100 ft of chain, which is better in 20 ft of water.  So typically we always put our the 80 ft of chain and then a minimum of 5 - 10 ft of nylon rode --- a built in snubber!

Check out thses linhs for information on how to size your chain and rode and how to anchor.  For details on chain types, strength and chain weight per pound, check this link.